bikinibottom/Turing Pi/odroid-hc4.md

Odroid HC4

Specifications

Form Factor	Board Dimensions: 84mm x 90.5mm x 25.0mm Heatsink Dimensions: 40mm x 32mm x 10mm Weight: 280g including heatsink, fan and case
Processor	Amlogic S905X3 Processor L1 instruction cache: 32 KB, 4-way set associative (128 sets), 64 byte lines, shared by 1 processor L1 data cache: 32 KB, 4-way set associative (128 sets), 64 byte lines, shared by 1 processor L3 data cache: 512KB , 16-way set associative (512 sets), 64 byte lines, shared by 4 processors Quad-Core Cortex-A55 (1.800GHz) ARMv8-A architecture with Neon and Crypto extensions Mali-G31 MP2 GPU with 4 x Execution Engines (650Mhz)
Memory	DDR4 4GiB with 32-bit bus width Data rate: 2640 MT/s (PC4-21333 grade) 1.2Volt low power design
Storage	1x Micro SD slot (DS/HS mode up to UHS-I SDR104)
Networking	1 x GbE LAN ports (RJ45, supports 10/100/1000 Mbps) Realtek RTL8211F (Ethernet transceiver) LED indicators * Green LED: Flashing by data traffics at 100Mbps connection * Amber LED: Flashing by data traffics at 1000Mbps connection
Video	1 x HDMI 2.0 (up to 4K@60Hz with HDR, CEC, EDID) Although the +5V Power pin is able to supply a mininum of 300mA, a sink shall not draw more than 50mA of current from the +5V Power pin.
Audio	1 x HDMI digital output
Cooler	1 x Passive heatsink ( 40x32x10 mm ) on the CPU of PCB board 1 x Hydraulic Bearing FAN Rated Voltage : 5V Rated Current : 100mA Max Speed RPM : 4,000 Air Flow CFM : 4.3 Air Pressure (In H2O) : 0.053 Noise Level(dBA) : 23.9 Dimension : 40 x 40 x 10.6 mm Wire & Connector : 80mm, 4 pin 1.25mm pitch
External I/O	1 x USB 2.0 host port 1 x Debug serial console (UART) 2 x SATA Connectors
Other features	IR receiver for remote controller System LED Indicators: Red (POWER) – Solid light when DC power is connected Blue (ALIVE) – Flashing like heartbeat while Kernel is running. Solid On in the u-boot stage. Turns off if there is no bootable media. Red (HDD/SSD active) - Flashing while SATA HDD/SSD are reading or writing.
Power	1 x DC jack : outer (negative) diameter 5.5mm, inner (positive) diameter 2.1mm DC input : 14.5V ~ 15.5V - DC 15V/4A power adapter is recommended Power consumption with two ST2000DM006 HDDs : - IDLE(with HDD in spin-down) : ≃ 5.88W - Active(using SAMBA): ≃ 15.59W - Suspend: ≃ 0.29W

##### Setup

sheldon (192.168.1.16) pleb/transatlantique

Choose  "Exit to shell"
(switch to console then)
# netboot_default
# exit
(back to petiboot menu)

> Choose OS from the net install-able" image list...