Updates

tubes/tube_clip.scad

@@ -0,0 +1,44 @@
+// Provided under a Creative Commons Share Alike License
+// CC-BY-SA
+// Created by MacLemon
+
+// This Clip is used for mounting an LED strip to a pipe. Either place it between LEDs, or print from translucent material. I recommend using PET-G.
+
+//$fn=30; // Usually fine for rendering previews.
+//$fn=60; // Used for final rending to .stl. (Yes, this IS slow.)
+$fn= $preview ? 15 : 30; // uses 30 fragments for preview, 64 for rendering.
+
+pipe_diameter = 23.3; //mm Diameter of the pipe the clip shall hold on to.
+outer_diameter = 29; //mm Outer diamter of the clip. (How beefy the clip is.
+clip_width = 7; //mm Thickness of the clip. Shall fit in between LEDs.
+strip_width = 12.3; //mm How wide the LED strip to be mounted is.
+strip_height = 3.8; //mm Thickness, or how tall is the LED strip including an optional Epoxy cover.
+
+rounding = 1; //mm
+clip_thickness = outer_diameter - pipe_diameter; // mm
+
+minkowski(){
+    difference(){
+        hull(){ // ring + LED strip holder block
+            cylinder (r = outer_diameter / 2 - rounding / 2, h = clip_width - rounding, center = true); // Clip Ring
+            translate ([(pipe_diameter + strip_height) / 2, 0, 0])
+                cube ([ strip_height + clip_thickness - rounding, strip_width + clip_thickness, clip_width - rounding], center = true); // LED Block
+            translate ([(-pipe_diameter - strip_height) / 2, 0, 0])
+                cube ([ strip_height + clip_thickness - rounding, strip_width + clip_thickness, clip_width - rounding], center = true); // grip Block
+        }
+
+        // Remove LED strip cutout
+        translate ([(pipe_diameter / 2 + strip_height + rounding)/2, 0, 0])
+            cube ([(pipe_diameter / 2 + strip_height + rounding), strip_width + rounding , clip_width * 2], center = true);
+
+        // Remove clip on section
+        translate ([-sqrt(2 * pow(outer_diameter, 2))/2, 0, 0])
+            rotate ([0, 0 ,135]) {
+                cube ([outer_diameter, outer_diameter, clip_width * 2 ], center = true);
+        }
+
+        // Remove pipe
+        #cylinder (r = pipe_diameter / 2 + rounding, h = clip_width * 12, center = true);
+    }
+    sphere (r = rounding);
+}